Rikon Power Tools 10-351, Руководство оператора

Страница: 11 / 36

ADJUSTMENTS
TOOL STORAGE
Storage for the “L” Hex Wrenches is provided for quick
access when adjustments are needed. Place the (4)
wrenches (3mm, 4mm, 5mm and 6mm) in the tool
holder on the rear column support (Fig.5).
A Hex Socket Screw and Nut (#34, 35) are provided
to hang the push stick. Install this hardware on the left
side of the column, in the prepared threaded hole.
SETTING THE TABLE SQUARE TO SAW BLADE
The table may be set at 90° to the saw blade sides
by adjusting the table stop screw (A-Fig.6) under the
table. The table stop screw rests on the top of the
quick release adjustment stop (B-Fig.6). First loosen
the locking nut (C-Fig.6) and set a square between
the blade and the work table. Adjust the table stop
screw (A-Fig.6) until the table and blade are set at 90°.
Retighten the locking nut (A-Fig.6) making sure that the
setting is maintained.
The table may also be set at 90° to the back of the saw
blade by adjusting the four trunnion micro adjustment
screws found in the base of the lower trunnion (A-Fig.7).
Slightly loosen part #134 mounting bolt (refer to parts
explosion on page 28 of this manual). Using the 3mm
“L” wrench provided, turn the trunnion micro adjusting
screws #266, as needed, to achieve desired setting.
Turning the screws clockwise will raise the trunnion;
counterclockwise will lower. Check table for 90° and
tighten part #134.
NOTE: The Trunnion (Fig. 7) is shown removed from
bandsaw for clarity. Micro adjusting screws are raised
to exaggerate their location. Only two of the four micro
adjusting screws are shown.
TILTING THE TABLE
Loosen the lock handle (A-Fig.8) on the table trunnion.
Turn the table tilting knob (B-Fig.8) to adjust the table to
the desired angle. Use the angle indicator scale on the
trunnion bracket to find the desired angle. Retighten the
lock handle to secure the table.
Figure 5
11
Figure 6
Tool Holder
A
B
Figure 7
Figure 8
A
B
A
C
Mounting Bolt
Location
Underside of Table