Rikon Power Tools 10-351, Руководство оператора

Страница: 20 / 36

20
TROUBLESHOOTING
CHANGING THE MOTOR DRIVE BELT
(Refer to “Frame Assembly” parts diagram on page 24)
Before changing the belt, make sure that the bandsaw is unplugged from the power source.
Release the saw blade tension from the drive belt by turning the quick release blade tension lever.
Release the drive belt tension by using the blade tension hand wheel (Part #62).
Remove the lower wheel (Wheel Assembly, Part #98) by removing the hex head bolt and washer in
the middle of the wheel’s hub. Carefully slide the lower wheel off of the lower wheel shaft, and at the
same time remove the saw blade from this wheel.
Remove the old drive belt from the wheel’s pulley, and install the new belt. Make sure that the ribs in
the drive belt are seated correctly in the pulley before reassembling and tensioning the drive belt.
Reverse the procedure to re-assemble the saw parts. Tension the drive belt until there is 3/8” to 1/2”
of deflection.
NOTES
Use this section to record maintenance, service and any calls to Technical Support.