图
1
图
1
Figure 1
10
Figure 2
INSTALLING THE WORK TABLE
NOTE:
The table leveling bar is pre-installed at the
factory to hold table steady during shipping. It must be
removed before assembling the work table to the saw.
The work table is fastened to the upper table trunnion
with four M8x20 hex bolts and four M8 flat washers.
With the help of another person lift the work table onto
the upper trunnion. Slide the blade through the blade
slot until the threaded holes of the table align with the
through holes in the upper table trunnion. Tighten table
in place (Circled, Fig.1) with supplied fasteners using
the 13mm wrench provided.
INSTALLING THE TABLE LEVELING BAR
Locate the table leveling bar, two wing knobs and two
washers (A-Fig.2 Inset).
Insert a wing knob and washer through the left hole of
the table leveling bar and into the threaded hole on the
left side of the blade slot (B-Fig.1). Make sure that the
opening of the slot on the right side of the table leveling
bar faces toward the table trunnion. This will allow the
table leveling bar to open outward from the bandsaw.
RIP FENCE RAIL
The Rip Fence Rail has been pre-assembled to the
work table for shipping. After mounting the work table
to the trunnions (see above instructions), the rail should
be checked to ensure that it is still properly tightened
in place to the table. If adjustments are needed, loosen
and/or re-tighten the four hex nuts on the fence bar
support shafts that extend through the table’s front skirt
edge (A-Fig.3 ). The four nuts will also be used for drift
adjustments, described on page 15.
NOTE:
It may be necessary to open the table leveling
bar to gain access to the right side fence bar stud.
UPPER GUIDE RAIL COVER
Install the plastic Guide Rail Cover (#88) into the square
hole on the top of the upper frame. This cap protects the
guide post (#195) when it raises above the saw.
ASSEMBLY
Figure 3
Underside of Table
Table Leveling Bar
B
A
Fence Rail
A
Underside of Table
A
Guide Rail Cover
Bandsaw
Figure 4
Содержание 10-351
