Rikon Power Tools 10-324TG, Руководство оператора

Страница: 12 / 44

12
ASSEMBLY
RIP FENCE ASSEMBLY
1. Mount the fence Guide Rail (#11F) onto the front
table edge with the two fence bar Nuts and Washers
(#15F, 16F) Fig. 5. Position the bar so that it is parallel
with the table surface, an d equal distance out from
the front edge of the table when measured at both left
and right front edges of the table.
2. Slide the Fence Carrier (#6F) and Fence Assembly
onto the fence’s guide rail. Fig. 6.
3. Lock the fence carrier in place on the rail by
tightening the fence Lock Knob (#7F), which is located
on the front of the carrier. Fig. 6, A.
4. Final adjustments to the fence are covered on
pages 19 and 20. Information on the re-saw bar is on
page 22.
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE OFF POSITION UNTIL ASSEMBLY IS COMPLETE.
FIGURE 5
FIGURE 6
INSTALL THE HAND WHEELS
1. Attach the Handwheel (#31D) to the upper right
side of the saw frame with the 5mm hex wrench. This
wheel raises and lowers the blade guard. Fig. 7, A.
3. Attach the Handwheel (#26E) to the lower right
side of the frame with the 5mm hex wrench. This
wheel adjusts the motor drive belt tension. Fig. 7, A.
4. Install the Blade Tension Handwheel (#1C) to the
top of the saw frame. No tools are needed, as the
metal shaft of the handwheel has two simple pins that
engage the Blade Tension Rod (#2C). Fig. 7, B.
FIGURE 7
FIGURE 8
INSTALL THE TOOL HOLDER
1. Assemble the Tool Holder (#46A) to the column
rear with two Phillips Screws (#45A). Fig. 8.
Handy storage for the Hex Wrenches (3, 4, 5, 6mm).
B
A
A
On the rear, left corner lip of
the table install the Fence
Support Bolt and Nut (#32B)
in the pre-bored and tapped
hole. When the fence is move
to the far left on the front rail,
the fence will be off of the
table, but it will be supported
in position on this bolt.
INSTALL THE FENCE SUPPORT BOLT