Rikon Power Tools 10-324TG, Руководство оператора

Страница: 10 / 44

10
STAND ASSEMBLY
KEY # DESCRIPTION QTY
1. Check the contents of the Stand against the parts list above, and lay out the parts for quick reference.
2. On a protected surface, lie the Upper Frame (#2) upside down so that the legs can be attached.
3. Attach the four Legs (#6) to the frame with the Carriage Bolts, Washers and Nuts (#5, 8, 7). Note that the
legs are universal and will attach to any corner of the stand. Do not fully tighten the nuts at this time.
4. Turn the Shelf (#4) upside down, fit it inside of the four legs and fasten it in place. Hand tighten the nuts only.
5. The stand is now assembled and can be turned upright.
6. Mount the Bandsaw to the assembled Stand with the four flat head Hex Bolts (#1).
This can be done in two ways; A) With assistance, lift the bandsaw and carefully position it in place on
top of the stand. Securely fasten it to the stand with the four bolts.
B) If alone, lay the bandsaw down on its column onto 4”x4” wood blocks. Then also lay the stand on its side
on wood blocks to match the bandsaw height and align the holes in the bandsaw base with those in the top
of the stand. Laying the saw and stand on blocks will allow you space to install the four bolts. With the stand
securely fastened to the bandsaw, tilt the saw upright off of the blocks.
7. With the bandsaw fastened onto the stand, any final shifting or leveling of the stand parts will be done
automatically by the weight of the saw. The final tightening of all of the nuts on the stand can now be done.
1
2
4
5
6 8 7
3
LINK TO 10-324TG
PRODUCT PAGE
AND
ASSEMBLY VIDEO
1 I
2 I
3 I
4 I
5 I
6 I
7 I
8 I
Hex flat head bolt M6x50
Upper frame
Hex nut with flange
Shelf
Carriage bolt M6x16
Leg
Hex nut M6
Flat washer
4
1
4
1
20
4
20
20
STAND PARTS
UPPER
FRAME
SHELF
4 LEGS &
HARDWARE
See Page 41 for the Stand’s Parts List