RIKA induo II, Руководство по эксплуатации

Страница: 21 / 28

|21
20
EN
12. CLEANING
Tip
Your RIKA dealer will gladly advise you about their service and
maintenance offers�
Depending on pellet consumption, a message prompting cleaning of
the stove appears on the display in regular intervals� This message
can be acknowledged on the Touch Display, while continuing
operation� Perform a cleaning cycle at the next opportunity�
Subsequently, reset the counter in the SETTINGS menu / RESETS
submenu, as per operating instructions of TOUCH DISPLAY�
Tip
The message will only stop reappearing once you have reset the
feed volume in the SETTINGS / Resets menu�
Note
Your stove must be switched off and cooled before any maintenance
work is performed� Only work on the unit when the mains plug has
been disconnected�
Cleaning the convection air openings
Vacuum clean any dust deposits from the convection air openings
at regular intervals�
The stove should be cleaned thoroughly prior to the start of the
heating season to prevent excess odour�
Note
To prevent your stove from overheating of the internal components,
do never cover the convection fins!
Combustion air - intake
If necessary, please also clean the air intake with a hoover�
Note
Only when the stove is cold! You could vacuum out embers – FIRE
RISK!
Cleaning the pellet container
Do not refill the completeley emptied container immediately; remove
the residues (dust, chippings etc�) from the bottom of the container�
The unit must be disconnected from the mains!
Bearings
annually
All built in bearings (pellet screw, turning grid) should be checked�
Clean or replace bearings depending on condition�
Checking door seal
annually
The condition of the seals at doors and glass should be checked at
least once a year� Repair or replace seals depending on condition�
Note
Only intact seals ensure your stove works perfectly!
Cleaning flue pipes
The flue pipes should be cleaned at least 2 x a year or after approx�
700 kg pellets� The flues are behind the combustion chamber�
Remove the hexagonal screws of both covers at the rear side�
Now you can remove the covers�
Loose the screws of the heat exchanger lids and remove them�
Clean the heat exchangers with the provided brush�
#8
#8