Riello SC SUN 300, Руководство пользователя

Страница: 10 / 36

10
INSTALLATION
HANDLING
The responsibilities of the user include providing the equipment needed to handle and unload the module, checking the
number of items delivered, and verifying the integrity of the material.
The module is positioned on a pallet; use only a transpallet truck for handling purposes and fix the pallet securely, bearing
in mind that the module will be at risk of tipping over if not restrained, given its weight and high centre of gravity.
Take care that the module is not exposed to impact, and remove packing materials only after it has been positioned.
PRELIMINARY CHECKS
Before commencing operations, remove the packing with care:
-remove the box covering the module;
-remove the nylon film;
-remove the protective wooden cage.
Check that the module is perfectly intact. If the product is found to be defective or damaged, do not install or attempt to
repair it, but contact the dealer immediately.
Dispose of discarded packaging materials in accordance with current statutory regulations.
b
Ensure that safety valves are clearly visible and easily accessible.
b
The drain line serving the safety valves must be designed and installed in compliance with current standards.
b
The module must be positioned in close proximity to the storage cylinder. The system is sized assuming that the
length of the pipelines connecting the module and storage cylinder will be 4 metres (flow + return)
b
Before commencing any work on the product, make certain it is isolated from the mains power supply.
b
The product must be installed in conformity with the laws and standards applicable in the country of installation.
b
The liability of the manufacturer is limited to the supply of the product. The product must be installed adopting best
professional practices by suitably qualified persons working for a company that will assume full responsibility for
the completed installation.
ASSEMBLY AND START-UP
Bear in mind the following before installing the product:
- The module is designed to heat potable water, operating in conjunction with a storage cylinder. Any use deviating from
or unrelated to the intended use is considered improper. Do not connect the module directly to the heat generator.
- The product is not designed to be operated by persons (including children) with limited physical, psychological, sen-
sorial or mental capabilities.
- In the event that the conduit for the cable connecting the module to the mains is damaged, it must be replaced only by
an expert service technician.
- The installation must comply with all applicable laws and standards.
b
Installation and connection of the product must be performed by an authorised, specialist company. The company
installing the product assumes all responsibility for ensuring that the installation and functioning of the product
conform to applicable standards.
b
The product must be stored in a dry place, protected from frost. The product must be installed where it is protected
against water splash. Ambient temperature in the place of installation must not exceed 40 °C during operation of
the product.
b
It is advisable to install the product as near as practically possible to the storage cylinder, in order to avoid unnec-
essary heat loss from the connecting pipes. The product must be placed a surface that is flat and stable, as far as
possible, and levelled up by means of the adjustable feet provided.
b
Be certain to adjust the feet of the module as appropriate, so as to avoid stresses.
WATER CONNECTIONS
Connections to the various pipes of the system are made as indicated on the stickers affixed to the module and in ac-
cordance with the layout diagram in this manual. The pipelines connecting with the storage cylinder must be as short as