Riello BGK3, Инструкции по установке, использованию и обслуживанию

Страница: 20 / 60

20013962
18 GB
Operation
8.4 Pump pressure
The pump leaves the factory set at 12 bar.
To change it act on pump pressure adjust screw 5) (Fig. 9).
8.5 Combustion head setting
Combustion head adjustment varies depending on burner de-
livery.
To adjust, proceed as follows:

turn adjusting screw 2) (Fig. 16) clockwise or anticlockwise
until the notch on the regulating rod 3) is lined up with the
outer surface of the nozzle-holder assembly 1).

In the example, the regulating rod 3) is set to setpoint 2; this
means the burner is adjusted for an output of 4.9 Kg/h with
a pump pressure of 12 bar using a 1.25 GPH nozzle, as
indicated in the reference Tab. A page 17.
8.6 Air damper adjustment
To adjust the air damper proceed as follows:

loosen nut 5) (Fig. 16) and set the valve by adjusting the
screw 4).

When the adjustment is complete screw down nut 5).
8.7 Electrodes adjustment
To reach the electrodes, proceed as described in the paragraph
9.3 “Maintenance position” page 22.
Do the following make the regulation:

lean the diffuser disc-holder assembly 3) (Fig. 17) on the
nozzle-holder 2) and lock it by screw 4).

For prospective adjustments of the electrodes assembly 5),
loosen screw 6).
8.8 Positioning optical fibre
To position the optical fibre, you must proceed as follows:

insert optical fibre 1) (Fig. 17) in the diffuser disc support
assembly 3), making sure it is pushed in all the way.

Tighten screw 4) carefully to hold optical fibre 1) in place.
WARNING
When the burner stops, the air damper closes au-
tomatically until maximum negative flue pressure
is 0.5 mbar.
Fig. 16
D9547
4 5 2
1
3
1
WARNING
MEASURES MUST BE RESPECTED.
Fig. 17
6
D9548
4.5
– 0.5 mm
0
3
± 0.3 mm
5.5
± 0.3 mm
5
2
3 4 1