Riello 20138572, Инструкция по установке, техническому обслуживанию и управлению системой

Страница: 101 / 112

101
SYSTEM MANAGER
SYSTEM MANAGER
7 SYSTEM MANAGER
7.1 Putting into service
9
The appliance must be maintained and adjusted at least
once a year by Technical Assistance Service or by profession-
ally qualified staff in compliance with all applicable Nation-
al and Local provisions.
9
Incorrect maintenance or adjustment may damage the ap-
pliance and cause damage to people or create a hazard.
9
The system manager is forbidden from opening and remov-
ing the appliance's casing. These activities must be carried
out only by Technical Assistance Service or by professionally
qualified personnel.
The thermal module Steel Pro Power
R
must be commis-
sioned by Technical Assistance Service
R
, after which step the
appliance may operate automatically.
However, the system manager may be required to restart the
appliance independently, without involving Technical Assistance
Service; for example after a long period of absence.
To do so, perform the following checks and operations:
− Check that the gas cock and heating water cock are open
− While the system is still cold, check that working pressure
in the central heating circuit is over 1 bar but below the
maximum limit specified for the boiler
− Adjust the room thermostats for the high and low tem-
perature zones to the required temperature (~20°C) or,
if the systems are equipped with timer thermostats or a
time programming unit, make sure it is on and adjusted
(~20°C)
− Switch the system's master switch to the ON position and
the thermal module's master switch to ( I ).
The appliance will go through the switch-on stage and, after
starting, it will continue to operate until set temperatures are
achieved.
The burner will then switch off and on automatically to main-
tain the set temperature without further operator action.
In the event of ignition or operation faults, the display will show
a numeric error code that will enable the user to interpret the
possible cause as detailed in Paragraph "Error List".
9
In the event of a permanent error, to reset starting condi-
tions press the "RESET" key and wait for the thermal module
to restart.
Repeat this operation 2-3 times at the most. If the problem per-
sists after that, call
R
’s Technical Assistance Service.
System manager