24
M
EASUREMENT DISPLAY AREA
The front panel can be used to display important UPS operating information.
When the UPS is switched-on, the display shows the main voltage value.
To display a different measurement, press the “SEL1” button repeatedly until the desired measurement appears.
Some measurements have more pages, press the “SEL2” to display them.
The functional diagram of the button “SEL1” and “SEL2” is shown below:
NOTE:
the measurement views of the mains (IN), is available in more pages only for UPS with three-phases input.
the views of FAULT / LOCK are not displayed in absence of anomalies, alarm or lock.
In the event of a fault/alarm (FAULT) or a lock (LOCK), the display will automatically show the type and code of the
corresponding alarm.
MEASUREMENT
DESCRPTION
IN
Display input mains data, such as voltage and frequency.
BYP
Display bypass line data, such as voltage, current and frequency.
OUT
Display the UPS output data, such as voltage, current and frequency.
BATT
Display batteries data, such as recharge percentage, autonomy estimation, voltage and
current. Display the recharging current with the mains present, otherwise the discharging
current if the UPS is on battery.
LOAD
Display the UPS load data, such as load percentage, apparent power (kVA) and active
power (kW).
TEMP
Display the temperature of: system (inside the UPS), Battery box (with optional probe),
power module and battery charger.
FAULT
(1)
Display the code of the anomaly or alarm active
LOCK
(1)
Display the code of the lock active
(1)
The FAULT / LOCK codes can only be displayed if they are active (presence of a fault/alarm or a lock).
