Riedel Bolero, Руководство пользователя

Страница: 60 / 84

60
Bolero User Manual A20
·
Select the ' Bolero ' tab.
·
Enter the same Bolero User ID that you entered in the
Antenna's web interface.
·
Edit the Multicast address.
A unique Multicast address must be used for each
Beltpack in the Director config.
Riedel recommends to use the start address
'239.255.0.1' for the Beltpacks Multicast addresses.
Figure 68: Properties of the Beltpack
The Beltpack's key functions can be defined now via Director.
The Beltpack is now able to talk to the Artist system and vice versa.
AES67 – Switch
Bolero
Beltpacks
Bolero
Antennas
AES67
AES67/Config
port
Artist
Frames
AES67 card
PC
AES67–1
port
××
×× ××
Figure 69: Bolero-Artist – Setup Diagram
Cable requirements: Cat 5e / Cat 6 or better (according to ISO/IEC 11801), S/FTP or better, up to 100 m.
Make sure ISO/IEC specification applies for the used length of the cable (in particular attenuation).
3.5.2 Switch Recommendations
This page describes all technologies that are needed for Bolero traffic and describes a simple network classification
that can be used to specify the switch that you need to choose.
After reading these pages, you should be able to determine, if a switch is suitable for Bolero by looking at
the spec sheet. If you classify the network you are building, choosing a switch can be done without
excessive testing.
The Bolero System needs the following key technologies supported by the switch fabric: