Riedel Bolero, Руководство пользователя

Страница: 57 / 84

57
Bolero User Manual A20
3.5 Features in Detail
3.5.1 Bolero-Artist Setup
This chapter describes the required steps to integrate a Bolero-System with an Artist-System.
The following devices are required:
ü
Artist frame with AES67 client card
ü
Bolero Antenna
ü
Bolero Beltpack
ü
Gbps Network Switch (optionally with PoE+ functionality)
·
Connect the 'AES67-1' port of the AES67 client card in the
Artist frame to the network switch.
·
Power up the Artist frame.
·
Connect the Antenna's 'AES67/Config' port to the network
switch. If a PoE+ switch is used, the Antenna is also
supplied with power.
·
Alternatively, attach a separate DC power supply to the
Antenna's power connector. Riedel recommends to use
the Bolero-Power-Supply 'BL-EPS-1005-00'.
After boot up, the IP address of the Antenna is shown in the
bottom right of the display (e.g. 192.168.41.150). The e-ink
display shows the current IP also when the Antenna is not
powered!
Figure 54: Antenna Display
·
Start the Artist configuration software ( Director ) on your
PC. For detailed information about Artist configuration
and setup please refer to the Artist and Director manual.
Verify that the IP address of the AES67 card in the Artist
frame is within the subnet of the Bolero Antenna:
·
Open the AES67 properties by right clicking on the
respective card and choosing "
Properties
".
Figure 55: Open the AES67 card properties
·
If necessary, edit the IP address and transfer the changes
to the Artist frame.
Figure 56: Properties of the AES67 card