Ricoh M160, Руководство по обслуживанию

Страница: 668 / 836

Error Codes
SM 12 M160/M161 Fax Option
Code Meaning Suggested Cause/Action
0-33 The data reception (not ECM)
is not completed within 10
minutes.

Check the line connection.

The other terminal may have a defective
modem/FCU.
0-52 Polarity changed during
communication

Check the line connection.
Retry communication.
0-55 FCU does not detect the SG3.

FCU firmware or board defective.

SG3 firmware or board defective.
0-56 The stored message data
exceeds the capacity of the
mailbox in the SG3.
SG3 firmware or board defective.
0-70 The communication mode
specified in CM/JM was not
available.
(V.8 calling and called
terminal)

The other terminal did not have a
compatible communication mode (e.g., the
other terminal was a V.34 data modem and
not a fax modem.)

A polling tx file was not ready at the other
terminal when polling rx was initiated from
the calling terminal.
0-74 The calling terminal fell back
to T.30 mode, because it
could not detect ANSam after
sending CI.

The calling terminal could not detect
ANSam due to noise, etc.

ANSam was too short to detect.

Check the line connection and condition.

Try making a call to another V.8/V.34 fax.
0-75 The called terminal fell back to
T.30 mode, because it could
not detect a CM in response
to ANSam (ANSam timeout).

The terminal could not detect ANSam.

Check the line connection and condition.

Try receiving a call from another V.8/V.34
fax.
0-76 The calling terminal fell back
to T.30 mode, because it
could not detect a JM in
response to CM
(CM timeout).

The called terminal could not detect a CM
due to noise, etc.

Check the line connection and condition.

Try making a call to another V.8/V.34 fax.