Ricoh M156, Руководство по обслуживанию

Страница: 21 / 169

Installation Requirements
M156/M157/M176/M177 2-2 SM

When disconnecting the power cord from the wall outlet, always pull the plug, not the
cord. Pulling the cord can damage the power cord. Use of damaged power cords could
result in fire or electric shock.

The printer weighs approximately 17.5 kg (38.6 lb.). When moving the printer, use the
inset grips on both sides, and lift slowly in pairs. The printer will break or cause injury if
dropped.

When moving the printer after use, do not take out any of the toners, nor the waste toner
bottle to prevent toner spill inside the printer.

Do not hold the control panel while moving the printer. Doing so may damage the control
panel, cause a malfunction, or result in injury.

Be careful when moving the printer. Take the following precautions:

Turn off the main power.

Close all covers and trays, including the front cover and bypass tray.

If optional paper feed units are attached, remove them from the printer and move them
separately.

Be sure to place the printer on a smooth and stable place.

Keep the printer level and carry it carefully, taking care not to jolt or tip it. Rough handling
may cause a malfunction or damage the hard disk or memory, resulting in loss of stored
files.

Protect the printer from strong shocks. Impact can damage the hard disk and cause
stored files to be lost. As a precautionary measure, files should be copied to another
computer.
1. Be sure to check the following:
The power switch is turned off.
The power cord is unplugged from the wall outlet.
The interface cable is unplugged from the printer.
2. Lift the printer by using the inset grips on both sides of the printer, and then move it
horizontally to the place where you want to install it.

Be sure to move the printer horizontally. To prevent toner from scattering, move the
printer slowly.