Ricoh M156, Руководство по обслуживанию

Страница: 119 / 169

Service Call
SM 6-3 M156/M157/M176/M177
T
ro
u
b
le
s
h
o
o
ti
n
g

Polygon motor/driver board harness loose or disconnected

Polygon motor/driver board defective

Laser optics unit defective
1. Turn the machine main power off/on.
2. Replace the interface harness of the laser optics unit.
3. Replace the laser optics unit.
220
Beam Synchronize error
The laser synchronizing detection signal for LD is not output within 400msec after
the LD unit has turned on.

Disconnected cable from the laser synchronizing detection unit or defective
connection

Defective laser synchronizing detector

Defective LD

Defective Main board
1. Check the connectors.
2. Replace the laser optics unit.
3. Replace the Main board.
268
Laser Scanning Unit thermistor error
At power on, the temperature sensor in the optics unit detected a temperature
lower than -30°C for more than 4 sec.
-or-
It detected a temperature higher than 105°C for more than 1sec.

Thermistor disconnected (causes extremely low temperature reading)

Thermistor damaged and short circuited (causes extremely high temperature
reading)
1. Turn the machine's main power off, and then on.
2. Replace the thermistor.