Ricoh InfoPrint 1767, Руководство пользователя

Страница: 38 / 178

When printing on envelopes:
•
From the control panel, set the Paper Source based on the source in use. From MarkVision Professional, Print
Properties, or the control panel, set the Paper Type to Envelope, and select the envelope size.
• Use envelopes designed specifically for laser printers. Check with the manufacturer or vendor to ensure the
envelopes can withstand temperatures up to 230°C (446°F) without sealing, wrinkling, curling excessively, or
releasing hazardous emissions.
•
For the best performance, use envelopes made from 90 g/m
2
(24 lb bond) paper. Use up to 105 g/m
2
(28 lb bond)
weight for envelopes as long as the cotton content is 25% or less. All-cotton envelopes must not exceed 90 g/
m
2
(24 lb bond) weight.
•
Use only new envelopes.
•
To optimize performance and minimize jams, do not use envelopes that:
–
Have excessive curl or twist
–
Are stuck together or damaged in any way
–
Have windows, holes, perforations, cutouts, or embossing
–
Have metal clasps, string ties, or folding bars
–
Have an interlocking design
–
Have postage stamps attached
–
Have any exposed adhesive when the flap is in the sealed or closed position
–
Have bent corners
–
Have rough, cockle, or laid finishes
•
Adjust the width guide to fit the width of the envelopes.
Note: A combination of high humidity (over 60%) and the high printing temperature may wrinkle or seal envelopes.
Using labels
Print samples on the labels being considered for use before buying large quantities.
When printing on labels:
•
From Print Properties or the control panel, set the Paper Type to Labels.
•
Use only letter, A4, or legal-size label sheets.
•
Use labels designed specifically for laser printers. Check with the manufacturer or vendor to verify that label
adhesives, face sheet (printable stock), and topcoats can withstand temperatures up to 230°C (446°F) and
pressure up to 25 psi without delaminating, oozing around the edges, or releasing hazardous fumes. Do not use
vinyl labels.
•
Do not use labels with slick backing material.
•
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. Partial sheets
also contaminate the printer and the cartridge with adhesive, and could void the printer and cartridge warranties.
•
Do not use labels with exposed adhesive.
•
Do not print within 1 mm (0.04 in.) of the edge of the label, of the perforations, or between die-cuts of the label.
•
Be sure adhesive backing does not reach to the sheet edge. Zone coating of the adhesive at least 1 mm (0.04 in.)
away from edges is recommended. Adhesive material contaminates the printer and could void the warranty.
•
If zone coating of the adhesive is not possible, remove a 1.6 mm (0.06 in.) strip on the leading and driver edge,
and use a non-oozing adhesive.
•
Portrait orientation works best, especially when printing bar codes.
38