Ricoh AFICIO MP 6001, Руководство по обслуживанию

Страница: 1081 / 1351

Bit Switches - 1
D418 68 SM
System Switch 00 (SP No. 1-101-001)
No Function Comments
(8): Total number of burst error lines that occurred during non-ECM reception.
ƒ
EQM and rx level are fixed at "FFFF" in tx mode.
ƒ
The seventh and eighth numbers are fixed at "00" for transmission
records and ECM reception records.
Rx level calculation
Example:
The four-digit hexadecimal value (N) after "L" indicates the rx level.
The
high
byte is given first, followed by the
low
byte. Divide the decimal value of
N by -16 to get the rx level.
In the above example, the decimal value of N (= 0100 [H]) is 256.
So, the actual rx level is 256/-16 = -16 dB
3 Not used Do not change this setting.
4
Line error mark print
0: OFF, 1: ON (print)
When "1" is selected, a line error mark is
printed on the printout if a line error occurs
during reception.
5
G3/G4 communication
parameter display
0: Disabled
1: Enabled
This is a fault-finding aid. The LCD shows the
key parameters (see below). This is normally
disabled because it cancels the CSI display for
the user.
Be sure to reset this bit to 0 after testing.
6
Protocol dump list output after
each communication
0: Off
1: On
This is only used for communication
troubleshooting. It shows the content of the
transmitted facsimile protocol signals. Always
reset this bit to 0 after finishing testing.
If system switch 09 bit 6 is at "1", the list is only
printed if there was an error during the
communication.