Ricoh Aficio 2090, Сетевое руководство

Страница: 88 / 126

Appendix
80
9
WINS
Use the wins command to configure
WINS server settings.
For more information about WINS
server settings, see p.86 “Configuring
the WINS Server”.
❖
❖ ❖
❖
Viewing setting
The following command displays
the WINS server IP address:
msh> wins
Example output:
msh > wins
WINS Configuration:
Ethernet(ether):
WINS: On
primary server 0.0.0.0
secondary server 0.0.0.0
Current configuration:
p r i m a r y s e r v e r
192.168.0.200 secondary
server 192.168.0.220
hostname selve ScopeID
Note
❒
If DHCP is used to start from
the network, the current WINS
server address is displayed.
However, this address is not
displayed if DHCP is not used.
❒
If the IP address obtained from
DHCP differs from the WINS IP
address, the DHCP address is
the valid address.
❖
❖ ❖
❖
Configuration
Use the set command to make
WINS active or inactive.
msh> wins interface_name
{on|off}
• “on” means active and “off”
means inactive.
❖ ❖ ❖ ❖
Setting WINS Server Address
You can make settings for the
WINS server address.
msh> wins interface_name
{ p r i m a r y | s e c o n d a r y }
IP_address
• “primary” is for setting the pri-
mary WINS server address.
• “secondary” is for setting the
secondary WINS server ad-
dress.
*1
If you install the 802.11b interface
kit, you can set the command.
*2
If you install the 1394 interface
board, you can set the command.
AutoNet
Use the autonet command to config-
ure the AutoNet settings.
❖ ❖ ❖ ❖
Display
The following command displays
the current AutoNet settings.
msh> autonet
❖
❖ ❖
❖
Configuration
You can configure the AutoNet
settings.
m s h > a u t o n e t
interface_name [on|off]
Note
❒
Select [on] to enable AutoNet.
❒
Select [off] to disable AutoNet.
interface
name Interface to be config-
ured
ether Ethernet interface
wlan
*1
IEEE 802.11b interface
ip1394
*2
IEEE 1394 interface