Ricoh Aficio 2090, Сетевое руководство

Страница: 82 / 126

Appendix
74
9
❖ ❖ ❖ ❖
Community name configuration
You can set the community name
of the registered number.
m s h > s n m p n u m b e r n a m e
community_name
Note
❒
The community name must
consist of 15 characters or less.
❖ ❖ ❖ ❖
Access type configuration
You can select the access type from
those listed below.
m s h > s n m p n u m b e r t y p e
access_type
❖
❖ ❖
❖
Protocol configuration
You should use the following com-
mand to set the protocols to active
or inactive. If you set a protocol to
inactive, all access settings set to
use that protocol will be disabled:
msh> snmp {ip | ipx} {on | off}
• “on” means active and “off”
means inactive.
To change the protocol of an access
setting use the following com-
mand. However, if you disabled a
protocol with the above command,
making it active here will have no
effect.
msh> snmp number active
{ip | ipx} {on | off}
❖ ❖ ❖ ❖
Access configuration
You can configure the address of a
host depending on protocols used.
The network interface board ac-
cepts requests only from hosts
with addresses “read-only” or
“read-write” access type. Enter “0”
to have the network interface
board accept requests from any
host without requiring a specific
type of access.
msh> snmp number {ip |
ipx} address
Note
❒
To specify TCP/IP protocol, en-
ter ip followed by a space, and
then the IP address.
❒
To specify the IPX/SPX proto-
col, enter ipx followed by a
space, and then the IPX address
followed by a decimal, and then
the MAC address of the net-
work interface board.
The following is an example of
how to configure registration
number 3 with the IP address
192.168.15.16:
msh> snmp 3 ip 192.168.15.16
The following is an example of
how to configure registration
number 3 with the IPX address
7390A448, and the MAC address
00:00:74:62:5C:65:
msh> snmp 3 ipx 7390A448:
000074625C65
Access
type Type of access which is
permitted
read Read only
write Read and write
trap User is notified of trap mes-
sages.
no All access is denied.