JWI-586 DIGITAL WEIGHING INDICATOR
4
POWER
ON
SETUP
The following a series of operation is for internal settings which depend on the
operator's usage. The user is allowed to change the pre-shipment settings
according to the procedures below.
Operation Tips:
1. Press " SET " key to go to the next setup when the present setup is
completed.
2. Press " TARE " key to show each internal selectable setting in turn.
3. Press " GROSS/NET " key to enable or disable the shown internal settings.
4. " On " means ENABLE and " OFF " means DISABLE.
5. Press " ZERO " key at any stage to revert to normal weighing mode.
●
Setup for weighing units. ratio counting (pcs),percentage weighing (%) and
weight checking (Hi / Ok / Lo) functions.
1. Press " SET " key again (continue from the end of SOFTWARE
CALIBRATION), the display will show current weight unit (ex. kg) or existing
function.
2. Press " TARE " key to show each above setting and enable or disable the
settings by pressing " GROSS / NET " key.
The display will ONLY show the enabled settings from the above in turn by
pressing " SET " key then "GROSS/NET " key each time in normal weighing
mode.
♦
The pre-shipment enabled settings for this setup are
kg
,
%
and
pcs
. (
lb
is
only additionally enabled for the U.S.A.)
