Richpower GENESIS GHD1260, Руководство оператора

Страница: 9 / 44

9
English
OPERATIOn
WARnIng:
Always check that the power supply corresponds to the
voltage on the rating name plate.
WARnIng:
Always be sure that the tool is switched off and
unplugged before adjusting, adding accessories, or checking a function on
the tool.
Trigger Controlled Dialable Variable Speed
WARnIng:
Before plugging in the tool, always check to see that the
tool is switched off.
your tool is equipped with a variable speed trigger switch. The tool speed is controlled by the amount
of pressure you apply to the switch trigger. By slowly increasing the pressure on the switch trigger,
tool speed will gradually increase until reaching maximum rated RPM.
To start the tool, simply pull the switch trigger. Increase tool speed by applying more pressure on
the switch trigger.
To stop the tool
, release the switch trigger.
“Lock-on” Button
The “Lock-On” button is located in the handle of your tool, beside the switch trigger and allows you to
continuously operate the drill at a preset RPM without holding down the switch trigger.
To lock the trigger “On”
, pull the switch trigger back fully, depress the “Lock-On” button and release
the trigger.
To unlock the trigger, squeeze the trigger back completely then release it without depressing the
“Lock-On” button.
Speed Control Dial
This feature enables you to preset the tool for a desired RPM when using the “Lock-On” button
feature. The tool speed is adjusted by rotating the “speed control” dial clockwise to increase the
speed and counter-clockwise to decrease the speed. Once you have set the speed you desire, when
the switch trigger is completely depressed and the “Lock-On” button engaged, the tool speed will
change to the speed you dialed in.
To preset a desired RPM
, pull the trigger back completely and engage the “Lock-On” button.
Maintain a firm grasp on the running drill with one hand and use your free hand to rotate the “speed
control” clockwise or counter-clockwise until the desired drill speed is reached. Then pull the trigger
back and release it to disengage the “Lock-ON” feature.
Once you’ve dialed in the desired drill speed , when you start the drill and engage the trigger
“Lock-On” button the drill will change to the speed you set with the “speed control” dial.
Forward/Reverse Lever
Located above the trigger is the forward/reverse lever. This lever is designed to allow you to select
the direction the drill chuck rotates. for drilling, hammer drilling and driving screws, the drill is run in
the forward or clockwise direction. Reverse or counter-clockwise rotation, is generally used to help
back out a drill bit from a hole and screw removal.
For forward rotation
, move the lever to the right.
For reverse rotation, move the lever to the left.
WARnIng:
Do not change the direction of rotation until the tool comes
to a complete stop. Moving the “forward/reverse” lever while the drill chuck is
rotating can cause damage to the tool.