Richpower GENESIS GHD1260, Руководство оператора

Страница: 10 / 44

English
1/2" Hammer Drill
Operator’s Manual GHD1260
10
WARnIng:
Always check the direction of rotation before tool operation.
WARnIng:
This drill is not designed for hammering in the reverse or
counter-clockwise direction. Failure to comply with this caution may cause
property damage.
Mode Selector Switch
The mode selector switch gives you the ability to operate this tool in two different modes. One setting
provides rotation only for driving screws and drilling holes in wood, metal, plastic and other non-
concrete material. The rotation only mode is also used for stirring paint, sanding, wire brushing, etc.
The second mode provides rotation and hammering action. Rotation with hammering action gives you
the ability to bore holes in concrete, asphalt, tile, brick or other similar hard materials.
To select the rotation only or drill mode, move the selector switch completely to the right, toward the
drill symbol .
To select the rotation with hammering action or hammer drill mode, move the selector switch
completely to the left, toward the hammer symbol .
(
nOTE:
To engage the hammering mechanism, apply and maintain pressure on the bit. When
pressure on the bit is released, the hammering action will stop and the rotation will continue
until the tool is switched off.)
When using the hammer drill mode for drilling into hard material like concrete, we recommend that you
use carbide-tipped percussion drill bits.
WARnIng:
Do not change the operating mode until the tool has come to
a complete stop. Moving the “mode selector” switch while the drill is operating
can cause damage to the tool.
Installing Bits
Inspect the drill bit shank and the drill’s chuck jaws for dirt or foreign matter and clean if necessary.
Dirt on the drill bit shank or on the chuck jaws can cause misalignment or bit slippage during use. Drill
bits larger than the hammer drill’s maximum rated capacity may cause the motor to overload and/or
gear damage.
WARnIng:
Failure to unplug the tool could result in accidental starting
causing possible serious injury.
To install a drill bit:
• unplug the hammer drill.
• Open the chuck jaws so the opening is slightly wider than the drill bit being installed.
• Position the drill so the chuck is pointing upward then insert the drill bit, allowing the bit to rest on
the bottom of the chuck. for small bits, insert the drill bit so that the bottoms of its flutes are even
with the top of the chuck jaws.
• Center the bit in the jaws and hand tighten the jaws by rotating the chuck collar clockwise, being
sure the bit is properly aligned in the chuck jaws.
• Insert the chuck key into one of three holes in the chuck, turning the chuck key clockwise to
securely tighten the chuck. Do not use a wrench, pliers, or means other than the chuck key to
tighten or loosen the chuck.
To remove the drill bit:
• unplug the hammer drill.
• Loosen the chuck by inserting the chuck key into one of the three holes in the chuck and turn it
counter-clockwise.
• Remove the drill bit from the chuck.