北京锐志天宏科技股份有限公司
Beijing RichAuto S&T Co., Ltd
Forging ahead, create future together!
57
2)
User has selected the wrong tool bit which is not the same as it set in process file.
3)
Check if there is any problem with the path processing file.
The screen displays “exceed limit” during processing
1)
The machine hasn‟t returned ZERO, lead the system is unable to confirm the actual
position. Solution is to go machine ZERO.
2) The reserved processing range is small than the actual file size after user set work
piece origin. Confirm the actual file size and then set a correct working origin.
3) Set wrong working origin in the process of creating processing file path. Check the file
path, and then generate the correct one.
Hard limit triggering
1) If the machine has connected with hard limit, the hard limit switch maybe damaged or
the voltage setup status on X6 is wrong.
2) System has not connected with hard limit signal:Confirm whether connect other
signal wire to hard limit X6 port, if not, check voltage setup normal or not. If normal,
user could go to “MACHINE SETUP”-“Input Confi” and DISABLE X6 port, then go to
“SYSTEM SETUP”- “wipe cache”. If still can‟t solve this problem, user can upgrade
the system.
Z axis
（
spindle
）
fall down abnormally
（
too fast
）
and cause Z feed amount too much
during processing
1) Z axis working speed exceed the fastest speed cause Z axis loses its steps when
moving up. " MACHINESETUP " - " Max Spd Limit ", set the safe speed.
2) The coupling is loosen or transmission mechanism slipping. Re-adjustment the
connecting parts.
3) The signal wire connected between the interface board and the motor driver has got
interference. Adjust the circuit.
4) Processing file error. Check processing file, try to download the correct processing
