北京锐志天宏科技股份有限公司
Beijing RichAuto S&T Co., Ltd
Forging ahead, create future together!
58
file to U disk or handle internal.
5) There is something wrong
（
plug loosen or wire damaged or wire diameter is too
slimly
）
with the lines connecting Z axis motor and motor driver. Replace the lines.
Repeating the same processing file after returning back to the machine ZERO, Z
axis cutting depths are not as same as each other
1) Machining table is uneven or processing object not firmly fixed, re-milling the machine
table to adjust the flatness.
2) Z-axis origin detection switch repeat positioning accuracy error, causing Z axis
homing error each time. Replace a high-quality detection switch.
3) Too much interference in the Z-axis homing process to form a false Z
origin. Re-adjust the wiring.
The machine cannot stop after returning ZERO, and cause spindle hit the machine
body
Double press
“
”to check input signal (Origin detection switch signal). To do
self-test. Detect whether the signal is triggered or disconnected.
1) The origin detection switch is broken. Replace a new one.
2) The distance of the origin detection switch detection sheet beyond the detection
range(This problem is common occurs in optoelectronic and proximity switches) of
the switch, adjust the position of the test piece.
3) The origin detection switch to the interface board wiring aging or loosening. Check
the connections again.
4) The interface board is broken. Return back to us to repair.
5) 50-pin data cable is broken. Replace it with a new data cable.
The machine uniform moves to the reverse direction when backing to the machine
ZERO
