北京锐志天宏科技股份有限公司
Beijing RichAuto S&T Co., Ltd
Forging ahead, create future together!
29
which limits all moving speed.
Pos Spd Limit: Set the maximum forward speed of the machine tool, which limits all
moving speed.
Circle Limit :
①
Circle Limit (Maximum Processing Speed with Arc Instruction in Processing Program).
②
Circle Diameter (diameter limited when arc instructions are available in the processing
program).
7) Accel Setting
S Accl
①
Linear (Linear acceleration mode);
②
Curve (Curve acceleration mode).
Linear: System default: linear acceleration is 800 mm/s².
Crv Accl: Curve acceleration is 1000mm/s
2
, the proposed curve acceleration is 1-1.5
times of the linear acceleration value.
Accel Jerk: It refers to growth rate of acceleration, that
is acceleration‟s incensement per
unit time, which can alleviate the adverse effects caused by sudden acceleration and
deceleration of machine tools.
SkipSpd: Start speed of motion axis from stationary state. Not starting from 0, but starting
directly from a certain speed, so it can shorten the overall processing time, but this speed
shouldn‟t be too high. Too high, it will cause the motor losing steps, jitter and even whistle;
Set too small, it will reduce the operating speed of the entire graph.
8) I/O Port Setting
Input Disable: Enable or disable the input port. User can disable X5-X8 if there is no signal
on these ports. Prevent misoperation such as wiring error.
Input List: the functions list of the input ports, where users can view all the functions of the
input ports.
Output Disable: To open or prohibit the output signal, if some ports of the interface board
are not connected with any signal, you can choose to prohibit the signals of these
corresponding ports to prevent misoperation such as wiring errors.
Output List: The functions list of the output ports, where users can view all the functions of
the output ports.
