Rice Lake 482-AG, Техническое руководство

Страница: 46 / 60

482-AG Livestock Digital Weight Indicator
42 Visit our website www.RiceLake.com
6.1.2 Reporting Commands
Reporting EDP commands send specific information to the selected port. These commands can be used in both configuration
and weigh modes.
6.1.3 Special Function Commands
Reset Configuration
The RESETCONFIGURATION command can be used to restore all configuration parameters to their default values. Before
issuing this command, the indicator must be placed in configuration mode.
This command is equivalent to using the
DEFLT function on the TEST menu, see Section 3.5 on page 26 .
All load cell calibration settings are lost when the RESETCONFIGURATION command is run.
Soft Reset
The command RS will reset the indicator without losing configuration and calibration. It does reset consecutive number and
count mode.
6.1.4 Parameter Setting Commands
Parameter setting commands allow the operator to display or change the current value for a particular configuration parameter.
Current configuration parameter settings can be displayed in either configuration or weigh mode using the following syntax:
command<ENTER>
Parameter values can be changed only when the indicator is in the configuration mode using the following command syntax:
command=value<ENTER> , where
value
is either a number or a parameter value.
Use no spaces before or after the equal (=) sign.
If an incorrect command is typed or the indicator is not in the configuration mode, the indicator responds with
?? .
Command Function
DUMPALL List all parameter values
DUMPAUDIT List audit data information
P Write current displayed weight with units identifier, see Section 8.2 on page 50 for more information.
ZZ Write current weight and annunciator status, see Section 8.2 on page 50 for more information.
S Write one frame of stream format
VERSION Returns the currently installed firmware version
Table 6-2. Reporting EDP Commands
Command Description Values
SC.GRADS Graduations 1–100000
SC.ZTRKBND Zero track band 0.0-3.0
SC.ZRANGE Zero range 1–100
Example: to make it 5%, enter "SC.ZRANGE=5")
SC.INIZR Initial zero range 0–100 (if set to zero, no initial zero is performed)
SC.MOTBAND Motion band 0.0–100 (in display divisions)
Example: to enter 5 divisions, send
"SC.MOTBAND=5.0"
SC.OVRLOAD Overload FS+2%, FS+1D, FS+9D, FS
SC.DSPRAT Display Rate 0.1 SEC, 0.25 SEC, 0.5 SEC, 0.75 SEC, 1 SEC, NONE
SC.SMPRAT Sample rate 5HZ, 40HZ, 20HZ, 10HZ
SC.DIGFIL Select Digital Filter Type ADAPTIVE, ROLLING, OFF
SC.AFILTER.SENSITIVITY Adaptive digital filter cutout sensitivity LIGHT, MEDIUM, HEAVY
SC.AFILTER.THRESHOLD Adaptive digital filter cutout threshold 0–999999
SC.RFILTER.SENSITIVITY Digital filter cutout sensitivity 2OUT, 4OUT, 8OUT, 16OUT, 32OUT, 64OUT, 128OUT
Table 6-3. CONFIG EDP Commands
Note