GB
7
•
To grind saw blades with set teeth, the motor (e) must be
titled to the set angle of the saw blade.
•
Then adjust the angle to the set of the teeth you have not
yet ground and grind those teeth as described above.
H. REMPLACING THE POWER CABLE
If the power cable for this equipment is damaged, it must be
replaced by the manufacturer or its after-sales service or
similarly trained personnel to avoid danger.
I. CLEANING, MAINTENANCE AND ORDERING OF SPARE PARTS.
Always pull out the mains power plug before starting any clearing
work.
Cleaning
•
Keep all safety devices, air vents and the motor housing free
of dirt and dust as far as possible. Wipe the equipment with
a clean cloth or blow it with compressed air at low pressure.
•
We recommend that you clean the device immediately
each time you have finished using it.
•
Clean the equipment regularly with a moist cloth and some
soft soap. Do not use cleaning agents or solvents; these
could attack the plastic parts of the equipment. Ensure that
no water can seep into the device.
Maintenance
Replacing the grinding wheel
When the grinding capacity of the equipment falls noticeably, the
grinding wheel should be replaced.
•
Undo the three screws on the grinding wheel cover (h) and
remove it (Fig. 9)
•
Insert the pin in the opening and slowly turn the grinding
wheel (l) by hand until the pin block the equipment’s drive
shaft (Fig.10).