GB
6
•
Important. Do not move the motor so far forwards that the saw
blade can be touched by the grinding wheel.
•
Adjust the stop (p) so that the grinding wheel (l) cannot be
moved beyond this position into the saw blade and secure it in
this position using the Allen screw.
Setting the tooth set angle
In addition to the tilt angle of the motor (e) the saw blade set must
be adjusted accordingly for set saw blades. For this purpose undo
the two nuts, tilt the motor (e) until the required angle is shown on
the scale (o) and secure it by tightening the two nuts.
G.
Operation
ON/OFF switch
•
Set the ON/OFF switch (q) to the “I” position to switch on the
equipment.
•
Set the ON/OFF switch (q) to the “0” position to switch off
the equipment.
Grinding saw blades
Proceed as follows to grind saw blades:
•
Switch on the equipment.
•
Turn the saw blade so that the grinding wheel (l) is between
the saw blade teeth and then move the grinding wheel (l)
as far as possible to the front using the handle (g) (Fig. 7)
•
Turn the saw blade slowly and carefully in a clockwise
direction into the rotation grinding wheel (l) and grind the
carbide metal plates on the saw blade until their cutting
edge has been sharpened (Fig. 8). If the grinding wheel is at
12 o’clock, your hands must be at 3 o’clock and 9 o’clock
on the saw blade.
•
Turn the saw blade back anti-clockwise so that the grinding
wheel (l) can run freely between the saw blade teeth. Move
the motor (e) to the rear again using the handle (g).
•
Turn the saw blade one tooth further and repeat the process
until you have sharpener all the teeth.
Grinding set saw blades
