Page
11
/
21
may cause fire. See Table 3 for more information.
•
Recharge the battery pack with specifically designated Ribimex chargers (not included).
Use of other chargers may cause fire. See Table 2 for more information.
•
Refer to the instruction manual of Ribimex battery pack and charger for safety, quality and
operation instructions.
IV. GETTING STARTED
4.1- Unpacking
•
Remove the product from packaging
•
Check if the product and accessories (if any) are intact.
4.2- Content
•
1 polisher body
•
1 backing pad
•
1 handle
•
1 polishing pad
•
1 foam pad
•
1 instruction manual
4.3- Assembly
WARNING!
Before starting assembly or changing accessories, turn it off and remove the battery
pack.
Installing the side handle (3)
•
The side handle could be installed from the left, right and top sides of the gear housing.
Install the side handle in the position that offers the best grip, control and protection.
•
Turn the handle into the handle Socket (4) and tighten securely.
Installing the backing pad (1)
•
Hold down the spindle lock button (2).
•
Align the backing pad to the spindle, then manually turn pad until it is tightened.
•
When the backing pad is securely attached to the machine body, release the spindle lock
button.
Removing the backing pad (1)
•
Hold down the spindle lock button (2).
•
Manually turn backing pad until it is detached from the machine body.
•
Release the spindle lock button.
Installing the polishing pad (7)
•
Turn the machine over so that the backing pad (1) velcro is facing up.
•
Select a suitable polishing pad (foam pad or polishing pad).
•
Attach the polishing pad to the backing pad velcro appropriately. Make sure the polishing
pad is center aligned.
