Page 8
Power Connections
NOTE:
Complete this section once the lights, wire harness and push-pull switch have
been installed.
CAUTION
: This light kit is designed for 12V DC operation only. Please be advised that
operating this light kit at a voltage over 12V DC can damage components and will void
any and all warranties.
1. Verify the cart is in the TOW position (if equipped) and the key is OFF.
2. Verify any exposed wires and the push-pull switch are not touching the frame or any
metal parts on the cart.
3. Connect the positive and negative
battery connections from the light kit’s
harness to the batteries. Tighten the
nuts but do not over tighten. Over
tightening can destroy the battery
posts.
Gas Carts: Connect the wires to the
12V battery.
48V Electric Carts with 8V Batteries
for 12V Output: A voltage reducer is
required to reduce the voltage to 12V.
Note:
Light sparks can be normal
when connecting the batteries, but a
bright arching flash indicates there is a
short in the system. The diagram on
the right shows the batteries in factory
configuration. Always test the batteries
with a voltage meter as each
configuration may vary.
4. Put the cart in the RUN position (if equipped) and turn the key ON.
5. Turn the lights ON and test them to make sure they function properly.
6. Secure any loose wires with cable ties.
Your TXT Light Kit is now complete.
Please enjoy safely!
Scan QR code or use the link below to view the installation video.
https://vimeo.com/user39935056
