Page 6
5. Route the taillight
leads to the holes
that were cut out for
the taillights. The
shorter lead will go
over the driver side
inner fender. The
longer lead will go
behind the battery
pack and over the
passenger fender.
6. Route the front portion of the harness through the vertical channel on the driver side.
Loosely secure with cable ties.
7. Route the push-pull switch over
the chassis and into the dash
area. The headlight leads will
remain in front.
Push-Pull Switch Installation
1. Remove the center compartment from
the dash by removing the (5) screws.
Use caution not to damage any wires.
2. If powering the lights with a push-pull
switch, locate a free space near the key
switch area (shown in yellow) to install
the push-pull switch. This area should be
free and clear of wires and accessories.
3. Mark the center of the mounting location
and drill a 1/2” hole. File rough edges.
Head
Lights
TO DASH AREA
Push-Pull Switch
