Page 5
4. Use a jigsaw or rotary tool to cut out the
INSIDE of the marked area. Test fit the
taillight. If needed, make any modifications
and retest. Once it is fitted properly, remove
the tape and sand any rough edges.
5. Flip the template over and complete Steps
2-4 for the driver taillight.
Wire Harness Installation
1. Completely remove the front seat bottom assembly.
2. Lay the harness parallel to the driver side of the cart to help with orientation of the
harness before installation.
3. From underneath the driver side of the cart, gently run the rear portion of the
harness (taillight & battery connections) through the (3) openings in the frame,
starting at the front and working towards the rear.
4. Route the taillight and battery connections up through the access hole that leads to
the battery compartment. Set the battery leads to the side. They will be connected
after installation of the harness and lights.
