RT-500-M
RHOTHETA
Page 132 of 168
User Manual
Note
Depending on the connection set-up (cable length, etc.), the supply voltage/current values can slightly
differ from the values that e.g. are adjusted on the power supply devices.
7.4.5.1 Update
DCU
The “Update DCU” dialog is opened by pressing the corresponding hotkey when the service menu is
opened (s. Figure 163, position 2). To load new software use the USB interface (s. chapter 6.2, Figure
9, position 11).
The function of this dialog is the updating of the DCU software, if a new version is available. In such a
case the dialog has the following appearance (s. Figure 164).
Note
In the case of unavailability of the new software version, the dialog will merely show the current
version without the possibility to take any action inside the dialog.
The hotkey “Start Update” appears, if a flash drive with a valid software version has been detected.
The new software version is then displayed in the dialog under the label “New Version”.
Figure 164. Update DCU dialog, new version available
o
Pressing the hotkey “Start Update” will start the update from USB.
During the update, the text of the hotkey changes to “Update…” (s. Figure 165) and the
warning at the top of the display appears.
Figure 165. Update DCU in progress
After a successful update the button name turns back to “Start Update”.
Содержание RT-500-M
Страница 1: ...User Manual RT 500 M ...
Страница 161: ...RT 500 M RHOTHETA Page 161 of 168 User Manual 13 3 Setup Tree View Settings ...
Страница 164: ...RT 500 M RHOTHETA Page 164 of 168 User Manual 13 5 Scan Page Tree View Settings ...
Страница 168: ...RT 500 M RHOTHETA Page 168 of 168 User Manual 14 Notes ...