Rhotheta RT-500-M, Руководство пользователя

Страница: 119 / 168

RT-500-M
RHOTHETA Page 119 of 168 User Manual
Port
This setting defines, which communication port is connected to the remote control PC.
o
For changing the communication port, press either the hotkey “COMx” (s. Figure 143,
positions 1, 2 and 3) or the hotkey “Edit Value” while the menu item “Port” is marked (s. Figure
143, position 5).
o
Using the hotkey for “COMx” in the top level dialog “NMEA DF Remote Configuration”,
changes the value of the “Port” setting without opening the corresponding dialog.
o
Pressing the hotkey “LAN Yes/No” (s. Figure 143, position 4) will turn on the additional
communication over LAN (pressing this hotkey again will turn the LAN communication off, see
also 7.4.4.3).
If COMx and LAN are set for remote control, the priority between both is time-based.
Example:
Î
Command for squelch comes via LAN.
Î
Command for squelch comes via COM.
Í
First, the squelch level gets adjusted on the LAN command. During this time the
message from the COM port is buffered.
Í After that, the squelch level gets adjusted on the command from COM port.
o
Pressing the hotkey “Edit Value” while “Port” is marked, opens the following sub-dialog (s.
Figure 144).
Figure 144. Remote communication port configuration
o
Selecting “COMx” (s. Figure 144, positions 1, 2 and 3) configures the corresponding NMEA
interface as the remote communication port. Choose the new setting using one of the hotkeys,
which will then appear in the “New Setting” field.
Note
This setting will only set the corresponding communication port. Additional transmitting the
NMEA sentences over LAN should be set in the top level menu (s. Figure 143, position 4).
o
Press the hotkey “Set Default” to use the default value (COM3/LAN).
o
Confirm the setting with “OK” or leave the dialog without adopting the new value by pressing
“ESC”.