RHINO MNVR Series, Руководство пользователя

Страница: 68 / 206

59
4.2.2.4.1.6 Activate Pattern Function
In
X346H346H346H316H316H316H323H
Figure 4-36, input mode value in the No. blank, and click pattern button.
4.2.2.4.1.7 Auto Scan Setup
In
X347H347H347H317H317H317H324H
Figure 4-35, click border button. The interface is shown as in
X348H348H348H318H318H318H325H
Figure 4-40
X
.
Please go to Figure 4-32
X
, use direction arrows to select camera left limit
Then please go to
X350H350H350H320H320H320H327H
Figure 4-40 and click left limit button
Repeat the above procedures to set right limit.
Figure 4-40
4.2.2.4.1.8 Activate Auto Scan
In
X351H351H351H321H321H321H328H
Figure 4-36, click “Auto Scan” button, the system begins auto scan. Correspondingly, the auto
scan button becomes Stop button. Click stop button to terminate scan operation.
4.2.2.5 Aux function
In Figure 4-36, click Page switch button, you can see an interface is shown as below. See Figure
4-41. Here you can set auxiliary function. The aux value has relationship with the Aux button of
the decoder.
Figure 4-42
Click Page switch button, system goes to the following interface. The options here are defined by
the protocol. The aux number is corresponding to the aux on-off button of the decoder. See Figure
4-43.
 Direct Aux: It includes three items.
 It is to use RS485 command to control the peripheral device light on/off. Make sure the
connected peripheral device supports this function. Select Light from the dropdown list
and click On to turn the light on and click Off to turn the light off.

It is to use RS485 command to control the peripheral device wiper. Make sure the