Rhima DEKO 260iX, Руководство оператора

Страница: 25 / 40

Fault messages
In a Fault condition the fault display appears with the fault code. On unloading side the FAULT-
led turns red. By pressing
Info
the possible cause and recommended actions for the repair wil
be displayed. Service shall always be contacted and called for, if a Fault condition occurs.
By inserting the service code the chamber will be emptied automatically
to avoid danger of hot water.
The load must be reprocessed (the selected cycle must be run again)
always after incomplete cycle !
Nr Fault message Nr Fault message
1 Loading door has opened during the cycle 31 Unloading door stayed interlocked
2 Controlling temperature sensor T1 has short
circuit 32 Loading door interlock opened during the
cycle
3 Controlling temperature sensor T1 has open
circuit 33 Pressure sensor p1 has short circuit
4 Verifying temperature sensor T2 has short circuit 34 Chemical dosing under set value, pump 1
5 Verifying temperature sensor T2 has open circuit 35 Chemical dosing under set value, pump 2
6 Unloading door has opened during the cycle 36
7 There is not enough water in the chamber 37
8 There is water left in the chamber 38 Chemical tank 1 empty
9 Water heating failed 39 Chemical tank 2 empty
10 Pressure of circulation water too low 40
11 Overflow in chamber 41 Rinse aid tank empty
12 Chamber drained at wrong time 42
13 Water temperature above set limit 43
Drying air pressure too low.
14 Pressure of circulation water dropped too low 44 Flap of drying coil casing not open.
15 Drying air filters are unclean 45 Flap of drying coil casing not closed.
16 Difference between temperature sensors T1
and T2 is too high 46
17 Air heating failed 47
18 Drying temperature not reached in 40 mins 48 Pressure sensor p2 has short circuit
19 Drying temperature above set limit 49 Difference between pressure sensors is
too high
20 Communication failed between PLC and
oparating panel 50 Unloading door interlock opened during
the cycle
21 Water pump’s thermal relay tripped 51 Unloading door is not closed
22 Pure water pump´s thermal relay tripped 52 Electric board temperature too high
23 Water temperature below set limit 53
24 Drying temperature below set limit 54
25 Loading door not interlocked 55
26 Loading door stayed interlocked 56
27 Loading door is not closed 57
28 Drying valve not open 58 Pure water conductivity over set limit
29 Drying valve not closed 59
30 Unloading door not interlocked 60 Steam cooler overflows
25