44
7. Follow steps 4 to 1 in reverse order to reinstall the
screen cover and close the unit.
NOTE:
For Touchscreens with built-in Wi-Fi module,
proceed to cut jumper wire. By cutting this wire, the Wi-
Fi module is disabled. Any attempt to modify the wire
or modify the board will void touchscreen assembly
warranty. See Figure 105.
Figure 105. Cut to Disable Wi-Fi
XVers with KOR Units
1. Release the four snap fasteners to remove the front
cover panels from the unit. Remove the panels and
place them aside.
2. Remove the 5/16" Phillips screw that secures the
swing panel.
Figure 106. XVers with KOR Panel Removal
3. Remove the power and communication harnesses
attached to the back of the touchscreen.
4. Remove the touchscreen rear cover.
5. Cut Wi-Fi jumper per
Figure 105
.
Figure 107. Harness Removal XVers with KOR
6. Disconnect the antenna wire from the Wi-Fi module.
ANTENNA WIRE
Figure 108. Antenna Wire Removal
7. Follow steps 4 to 1 in reverse order to reinstall the
screen cover and close the unit.
NOTE:
For Touchscreens with built-in Wi-Fi module,
proceed to cut jumper wire. By cutting this wire, the Wi-
Fi module is disabled. Any attempt to modify the wire
or modify the board will void touchscreen assembly
warranty. See Figure 105.
Содержание Raypak Raymote
Страница 47: ...47 Notes...
