Rheem Raypak Raymote, Инструкция по установке и эксплуатации

Страница: 42 / 48

42
10. DISABLING RAYMOTE
This section describes the procedure to disable Raymote
functionality and components. This will ensure that no
signal is emitted or received by the antenna.
Before Removal
1. Terminate any active call for heat.
2. Disable the boiler operation in the BOILER menu, or
deactivate the enable switch on the unit.
3. Allow the unit to shut down.
4. Turn OFF the boiler main power switch. Make sure
the boiler is completely de-energized.
5. Locate the upper front of the boiler and follow the
instruction that apply to your product.
MVB and XTherm units
1. Remove the knurled screw that secures the front
sheet metal panel. Remove the front panel.
J-BOX COVER
ANTENNA
FRONT COVER
SCREW
RAYMOTE LOGO
DECAL
Figure 95. MVB and XTherm Front Panel Removal
2. Remove the j-box cover panel and the power switch
mounting panel. Discard the j-box cover panel. It
will be replaced with a new j-box cover panel which
includes an additional opening to allow for the
antenna placement.
Figure 96. J-Box Cover Removal
3. Remove the power and communication harnesses
attached to the back of the touchscreen.
4. Remove the (4) 5/16" hex screws from the
touchscreen mounting brackets on the j-box.
Figure 97. Harness Removal
5. Remove the touchscreen rear cover from the
touchscreen.
ANTENNA WIRE
WIRE NOTCH
Figure 98. Touchscreen Rear Cover Removal
6. Disconnect the antenna from the Wi-Fi module.
7. Remove the module from the back of the touchscreen.
8. Remove the antenna from the bracket. See
Figure 99 .
NOTE: For Touchscreens with built-in Wi-Fi module,
proceed to cut jumper wire. By cutting this wire, the Wi-
Fi module is disabled. Any attempt to modify the wire
or modify the board will void touchscreen assembly
warranty. See Figure 104.
MODULE CHIP
SD CARD
Figure 99. Antenna Removal