MAN1910117 V.7 – 15/11/2012
23
To protect all the data set into the PROGRAMMING mode and the access to the free-vend modality, it is possible
to introduce a 3 digits secret code; the machine requests this code every time somebody tries to enter into
PROGRAMMING mode or FREE-VEND mode pressing the
key
on the display board inside the machine and then
1
or
3
.
Entering
4
and
5
it is possible to set the secret code (from 111 to 888 with the exception of all the numbers
containing the digit 9; i.e. the machine accepts the code 123 but not the code 109). Exit from Programming mode.
Now when the
key
on the display board inside the machine is pressed if somebody tries to enter
1
or
3
the display
will show:
insert
access code
Enter the code pressing the selection buttons. If the inserted code is wrong the machines come back automatically
to vend mode. Normally the machines come out from the factory without any code stored:
code:
INHIBITED
and so it is possible to go inside the Programming mode and in free-vend mode. Entering again
2
, the video shows:
fan time
min. 15
entering
4
and
5
it is possible to modify the value of the time range between the end of the cycle of a drink and the
switching off of the aspiration fan. If you set this value at 0, the fan works only 1 minute. Entering again
2
, the video
shows:
beep time
0.3
Pressing again
button 2
, the display shows:
decimal numbers:
0
Pressing
buttons 4
and
5
it is possible to set the number of the decimal digits after comma according with the
values of the coins, which the machine has to accept (Es: 0=50, 1=5,0 2=0,50…). Pressing again
button 2
the
display shows:
First Installation
0 = First 1
Pressing
button 4
and
5
set this parameter at 0 to activate the First Installation procedure at the switching on of the
machine as described at the paragraph “
Start up operations
”.
Entering
4
and
5
it is possible to set the number of
the decimal digits after comma according with the values of the coins, which the machine has to accept (Es: 0=50,
1=5,0 2=0,50…). Entering again
2
, the video shows:
Tuning PUMP N
+ 00.0%
Setting this parameter you can adjust in percentage the quantity of the water dispensed from each pump of the
boiler. Entering
4
and
5
you can decrease or increase this value from –30% to +30%. Entering again
2
, the video
shows:
Tuning grinder
+ 00.0%
Setting this parameter you can adjust in percentage the quantity of coffee beans grounded from. Entering
4
and
5
you can decrease or increase this value from –30% to +30%.
At the end of the programming, enter
1
to confirm the set data.
