3. Programming
The receivers and modulators are simple to program with the remote control unit (RCU-800). The main
functions of RCU are shown in Fig 2.
1.
MENU
Main OSD menu
2.
INFO
Channel information
3.
OK
Confirm selection
4.
VOL
<
<
<
<
Audio volume, select left
(audio output only)
5.
VOL
>
>
>
>
Audio volume, select right
6.
EXIT
Exit from menu
7.
SYS
Add or remove programs to output MUX
8.
F1
BER
9.
EPG
Channel list
10.
∧∧
∧∧
∧∧
∧∧
Scroll channel list one page at a time
11.
∨∨
∨∨
∨∨
∨∨
Scroll channel list one page at a time
12.
CH
∧
∧
∧
∧
Change a channel, select up
13.
CH
∨
∨
∨
∨
Change a channel, select down
14.
UHF
UHF +
∧
/
∨
= set output channel
Fig 2.
3.1 Power-up
At power-up this welcome screen is displayed. Main SW and user interface SW version numbers plus unit
serial number are shown.
When the unit is powered the display lights up showing
selected output channels (Fig 1. no 2 ). The factory
set channels are E40 and E42.
The display is switched off after 3 minutes. Two signal led indicate that the unit is powered. The display
lights up again by pressing any button of remote controller unit.
Next program info for channel previously selected is displayed and the channel opened, if possible. Info
shows program name, transponder frequency, data rate, FEC and channel video PID number.
Please note that opening a channel will take longer time when a conditional access module is inserted. It is
recommended to use updated smart card. If the channel list is empty, welcome screen will remain
displayed.
RF-Tuote Oy, Joensuunkatu 13, 24100 Salo tel. +358-2736 6360, fax. +358-2-736 6355, [email protected], www.rf-tuote.fi
