RF Technologies ART400, Инструкция по установке, эксплуатации и программированию

Страница: 63 / 69

Commercial In Confidence
63
6.9.11 RTS/CTS HANSHAKE
On or Off can be selected
6.9.12 DCD
OPERATION
This option is used in conjunction with the internal modem and is used to select DCD line
active on detection of RF Only or RF and Data.
6.9.13 DTR SHUTDOWN
Enables DTR to be used for external power save.
6.9.14 LEAD IN DELAY
Selects the time the RF carrier is raised before the transmission of data via the internal
modem takes place, for more detail see the section of this manual describing transmit/receive
timing. The delay is programmable from 0 to 2500ms in 10ms steps.
6.9.15 LEAD OUT DELAY
Selects the time the transmitter remains up after the data has been sent. Used sometimes to
give a finite quiet pause after the data has been sent, for more detail see the section of this
manual describing transmit/receive timing. The delay is programmable from 0 to 2500ms in
10ms steps.
6.9.16 EMBEDDED
CONTROL
The embedded control addresses are used in conjunction with the network routing mode
discussed is section 5.
6.9.16.1 Network I.D.
The Network I.D can consist of up to 4 digits and differentiates one network or a sub network
from another.
6.9.16.2 Network Address
The Network Address is the actual address of the radio modem.
6.10 EDIT CHANNEL DATA
This field takes you into the Channel Data Screen
6.10.1 CHANNEL DATA SCREEN: