RF Technologies ART400, Инструкция по установке, эксплуатации и программированию

Страница: 2 / 69

Commercial In Confidence
2
CONTENTS
1.0 INTRODUCTION
1.1 Products Covered
1.2 Introduction
1.3
Overview
1.3.1 Radio Frequency (RF) Section
1.3.2 Transmitter
1.3.3 Receiver
1.3.4 MPU Control & Interface Board
1.3.5 Software
1.3.6 Custom Software
1.3.7 Continuos Development
1.4 Channel Selection
1.5
Programmability
1.6 Low Power operation
1.7 Power Save Mode
1.7.1 Internal Power Save Mode
1.7.2 External Power Save Mode
1.7.3 Time Scheduling using the RTC
1.8 Soft Modem
1.9 RSSI Receive Signal Strength Indicator
1.10 Status LED’s
1.11 Optional Keypad & Display
1.12 R.F. Power
1.13 Local I.O.
1.14 12C Internal & External BUS
1.15 GPS
1.16 Internal/External Modem Operation
1.16.1 External
1.16.2 Tone Operated Switch (TOX)
1.16.3 Internal
1.17 Modes of Operation & Protocol Handling
1.17.1 Radio Modem Modes of Operation
1.17.1.1 Dumb Modem
1.17.1.2 Protocol Specific Modem
1.17.1.3 Routing Modem
1.17.1.4 Dial-up Modem
1.17.2 I.O. Modes of Operation
1.17.2.1 Isolated Network with Point to Point I/O Mapping
1.17.2.2 Network with Retrieved Data Access at Base Station
1.17.2.3 Externally Controlled Network
1.17.2.4 Custom Protocols
1.18 Network Management Software
1.19 Squelch Tail Elimination
1.20 Forward Error Correction
1.21 Automatic Frequency Control
1.22 TX Time-Out-Timer
1.23 Dual Control for Fully Duplicated Outstation
1.24 Programming, Service Installation & Management
Software
1.24.1 Programming Software
1.24.2 Installation Software
1.24.3 Service Software
1.24.4 Network Management Software