RF IDeas pcProx Plus, Руководство пользователя

Страница: 56 / 70

rfid:cmd.prompt=True
This command displays the prompt when true. If false, the prompt does not display. This value can be
written to flash memory using cfg.write. It defaults to true on cfg.reset.
rfid:dev.luid=0x1234
This command sets the logical unit ID. A user-defined 2 byte value to identify this unit.
rfid:disp.64bit=False
This command uses 64 bit math to computer 64 bit decimal digits. This should always be kept on. If
true, it uses 64 bit math.
rfid:disp.fac.digits=3
This command truncates or sets the FAC display leading zero.
rfid:disp.fac.hex=False
This command sends the FAC code in hex when true. If false, the FAC code is sent in decimal.
rfid:disp.fac.send=False
This command sends the FAC code if true. If false, the FAC code does not display.
rfid:disp.fac.strip=False
This command separates the FAC from the card data when true so it can be independently formatted
for display. If false, the FAC code is not separated from the card data.
rfid:disp.id.digits=16
This command sets the digits so the left most significant digits will be truncated. For example, if the
card data is 1234 and id.digits=3, then only 234 displays. If the card data = 8 formats the display
width by truncating digits or adding leading zeros.
rfid:disp.id.hex=False
Displays the card data as hexadecimal when true. If false, card data displays as a decimal.
rfid:op.beep=True
This command sets the device to beep on a successful card read when true. If false, the device will
not beep even if the card is successfully read.
rfid:op.cont=False
This command sets the device to continuously read when true. It tells the device to read the same
card data over and over while the card is on the device. If false, the device only sends card data once.
rfid:op.sdk=False
This command stops the device from displaying the card data when true, so the qid or SDK API call
must be used to get the card data. When true the device will send the data via keystrokes or serial
depending on device type/model.
rfid:out.beep=False
This command makes the device beep when true. If false, the device will not beep. This is only
available on OEM converter boards.
56
Chapter 4 ASCII Command Protocol