Form I-UDA, P/N 195673 Rev 13, Page 3
1..1
Certification
Model UDAP 30, 45, 60, 75, 100, and 125 and Model UDAS 30, 45, 60, 75, 100, and
125 are design certified by the Canadian Standards Association for use in residential,
industrial, and commercial installations. Unit heaters certified for “residential use” are
intended to be used as supplementary heating devices in residential areas such as
workshops and garages. They are not intended to be the primary source of heat in
residential applications or to be used in sleeping quarters. Residential standards are
CSA CR-96-0005 and International Requirement 10.96.
Models UDAP 150, 175, 200, 225, 250, 300, 350, and 400 and UDAS 150, 175, 200,
225, 250, 300, 350, and 400 are design certified by the Canadian Standards Associa
-
tion for use in industrial and commercial installations only.
All models and sizes are available for use with either natural or propane gas. The type
of gas, the gas input rate, and the electrical supply requirement are shown on the
heater rating plate. Check the rating plate to verify that the heater is appropriate for the
installation site.
1.. Venting Manual
Installation requires both this manual
AND
the venting manual.
Venting Manual by Model
BOTH this manual
and the correct
venting manual
are REQUIRED for
installation of this
heater.
1. General
Installation
Information
WARNING: Do not use this appliance if any part has been
under water. Immediately call a qualified service technician
to inspect the appliance and replace any gas control that has
been under water.
Model
Venting Instruction Manual by
Form No.
Look for Matching Label on
Venting Manual and Heater
UDAP
Form I-UD-V-PV
,
Standard Power Vent Installation
(Each heater has its own dedi
-
cated vent.)
Label with
RED SQUARE
UDAP-CV
Form I-UD-V-CV
,
Optional Common Vent Installa
-
tion (Model UDAP heater must be
equipped with Option AV6.)
Label with
BLUE TRIANGLE
Note: Model UDAP-CV is available in Sizes 30, 45, 60, 75, 100 only
UDAS
Form I-UD-V-SC
,
Separated Combustion (Model
UDAS requires field installation of
either
Option CC2, CC6, or CC14
Vent/Combustion Air Kit)
Label with
GREEN CIRCLE
Both this installation manual and the appropriate venting manual are shipped with the
heater. Verify that the literature is correct for the heater being installed. If either manual
is missing or incorrect, contact your distributor before beginning installation.
The instructions in this manual apply
only
to the models listed.
Installation should be done by a qualified agency in accordance with these instructions.
The qualified service agency installing this heater is responsible for the installation.
