0710RHC8-JLNLEN
13
/
36
CAUTION :
Alterations to the burner and/or its controls, any
other electrical apparatus supplied as part of the
heating module or changing of the settings as
supplied is strictly forbidden. To do so is in
contravention of the E.C. gas appliance directive.
5.1.6 Thermal insulation used in the construction of
a heating module enclosure shall maintain its
insulating properties under the influence of
heat mechanical stress and ageing, it shall
be non- combustible and resistant against
vermin. Ensure that any insulation is securely
fixed and will not obstruct combustion air
pathways.
Asbestos or materials containing asbestos
may not be used.
All materials used in association with RHC
8000 modules must be in accordance with
the combustibility requirements of ISO 1182.
5.1.7 Where appliances containing RHC 8000(M)
DJL modules are intended to be suspended
at a height of 1,8 m above floor level, doors,
panels etc. intended to be removed for
servicing shall be provided with hinges, or
restraining devices to prevent falling from
above during servicing. Access panels must
be readily capable of correct and easy
removal and assembly, this feature is
particularly
appropriate
to
square
dimensioned elements.
NOTE:
Provision must be made to view the burner to
ensure its operation under normal operating
conditions. Viewing ports may be necessary.
Ensure no flammable substances are in the
immediate environment of the heating module.
6.0 G
AS
C
ONNECTION
(R
C
¾”
or
R
C
1
¼”)
Attention : All RHC 8000M units are designed
for a Rc 1 ¼” gas connection – all RHC 8000
units are designed for a Rc ¾” gas
connection!
6.1.1 National requirements and regulations for
the installation of gas must be respected
for all countries into which the appliance
is delivered. Gas connections may only
be carried out by appropriately qualified
persons.
6.1.2 Clearances around connections shall be
adequate so as to afford access to allow
the use of tools to connect and disconnect
the gas service connections.
6.1.3 Threads used for gas pipes and fittings
shall comply with ISO 7.1.
6.1.4 Copper pipes and fittings may not be
used. Solder which has a melting point of
less than 450
o
C neither solder or alloys
containing cadmium shall not be used.
6.1.5 All gas services to the heating module
shall be equipped with an isolation tap
which shall be of the 90
o
turn type and
shall be provided with a positive stop and
it should be fitted adjacent to the heating
module.
Such taps when installed in a vertical
position shall be such that in the event of
a falling handle the valve will be in the
closed condition, the open and closed
positing shall be readily distinguishable.
The valve shall be easy to operate when
required.
Attention : all passages for gas pipes, etc to
the control department must be completely
sealed !
