Reya BATVIEW 2, Руководство по эксплуатации и инструкция пользователя

Страница: 3 / 12

GENERAL CHARACTERISTICS CONTENTS OF BATVIEW PACKAGING
Batview2-rev 01 Batview2-rev 01
UK
4
A angled connectors
10 points
4
A angled connectors
6 points
4
A 300A 100mV shunt
4
A temperature sensor
4
A bag of fixing screws
4
A user manual
The Peukert coefficient allows the actual capacity
of a battery to be estimated. For example, a ca-
pacity of 100Ah is applicable for a C/20 discharge
rate, i.e. 5A per hour for 20 hours at an ambient
temperature of 20°C. However, this same battery
will provide less than 100Ah if the amperage used
exceeds 5A, or more if the amperage is lower.
It is therefore an intelligent battery management
system, which is able to automatically adapt to
any consumption or charge on one or two house
batteries, in such a way as to provide an extre-
mely precise indication of the remaining charge
percentage.
The BATVIEW2 is easy to connect and automatical-
ly recognises a 12V DC or 24V DC supply voltage
when it is powered on.
The BATVIEW2 is equipped with a non-volatile me-
mory allowing the configuration settings to be
stored, even when there is no power, when it is
reactivated.
The BATVIEW2 is not sensitive to cycling effects as
it automatically detects floating mode, which
means that the batteries are fully charged. It is
therefore not affected by measurement drift over
the course of successive charging and dischar-
ging cycles, which, for other management sys-
tems on the market, results in a need to comple-
tely reinitialise the charge status.
The shunt supplied is made from a special alloy,
which allows a voltage drop, calibrated in mV
(converted into amps by the management sys-
tem), to be measured. This value is etched on the
shunt as is the maximum amperage that can flow
through it. This maximum amperage is 300A for a
maximum of 5 minutes. The permanent ampera-
ge that can flow through this type of shunt is two
thirds of this value (200A).
GENERAL CHARACTERISTICS
The BATVIEW2 is a battery management system
that allows the voltage of 4 different sets of batte-
ries and the amperage of 2 different sets of bat-
teries to be measured (1 shunt supplied, a second
optional shunt is available).
A calculation algorithm based on the Peukert
exponent allows the charge percentage for two
sets of batteries to be displayed (if a second op-
tional shunt is used).