REXROTH EFC3600 Series, Инструкция по эксплуатации

Страница: 57 / 90

Rexroth connection diagrams are only to be used for producing in-
stallation circuit diagrams! The machine manufacturer’s installation
circuit diagrams must be used for wiring the installation!
●
Lay signal lines separately from the load resistance lines because of the oc-
currence of interference.
●
Transmit analog signals (e.g. command values, actual values) via shielded
lines.
●
Do not connect mains, DC-bus or power cores to low voltages or allow them
to come into contact with these.
●
When carrying out a high voltage test or an applied-overvoltage withstand test
on the machine’s electrical equipment, disconnect all connections to the devi-
ces. This protects the electronic components (allowed in accordance with EN
60204-1). During their routine testing, Rexroth frequency converters are tes-
ted for high voltage (in accordance with EN 61800-5-1:2007, section 5.2.3.2)
and insulation (in accordance with EN 60204-1:2006, section 18.3).
Risk of damage to the frequency converter by
connecting and disconnecting live connections!
NOTICE
Do not connect and disconnect live connections.
5.2.2 Allowed Mounting Position
a Mounting surface
g Direction of gravitational force
G1 Normal mounting positions. The natural
convection supports the forced cooling
air current. This avoids the generation of
pockets of heat in the component
G2 180° to normal mounting position
G3 Turned by 90° from vertical to horizontal
mounting position
G4 Bottom mounting; mounting surface on
bottom of control cabinet
G5 Top mounting; mounting surface at top
of control cabinet
Fig. 5-1: Allowed mounting position
Bosch Rexroth AG
Instructions for Use
DOK-RCON01-REX*F*UL***-IN10-EN-P
37/69