Rexing H2, Руководство пользователя

Страница: 21 / 32

21
Camera won’t take
images
Camera Won’t Power Up
Battery Life is Shorter
Than Expected
FAQ s
Photos did not capture
any subjects of interest
These are the result of placing the camera in an
environment where there is motion associated
with tree branches creating motion or an area
where there is high heat in the foreground and
any motion from wind. Setting a camera up over
water is also a potential cause for this issue. To
remedy this situation:
1. Try moving the camera to an area that does
not have any of these issues.
2. If the camera continues to take images of no
interest subject, try placing the camera in an
inside environment and aiming at a location
where there is no motion.
3. If the camera continues to show issues,
please contact our customer service.
1. Please make sure that the SD card is not full.
If the card is full, the camera will stop taking
images.
2. Check the batteries to make sure that they
are new alkaline.
3. Make sure that the camera power switch is in
the ON position and not in the OFF or TEST
modes.
4. If the SD card has its write protect switch in
the lock position,the camera will not take
images.
5. If you have used an SD card in another device
before, you might want to try formatting the
card before using it in the trail camera.
1. Make sure that you have installed at least a
full set of 4 batteries in correct position.
2. Make sure that the batteries are installed
correctly, observing proper polarity.
3. After moving the switch from OFF to TEST or
ON Mode , make sure that the switch is
correctly in position to ensure the proper
mode.
4. Do not move the switch directly from ON to
TEST , always move the switch all the way
down to OFF first, then back up to TEST .
1. Battery life varies with operating temperature
and the number of images taken over time.
Typically, the camera would be able to capture
several thousand images before the batteries
die.
2. Check to make sure you have used new
alkaline batteries.
3. Make sure that the power switch was turned
to the ON position and not in the TEST
modes.