Rexing H2, Руководство пользователя

Страница: 15 / 32

15
Camera Operation
Reset to Factory S etting
Select Yes and press OK to restore all
parameters to the original factory default settings.
Aligning t he Camera
In TEST mode , you can work out the optimum
exposure angle and the range of the motion
sensors.
During alignment, consider whether the use
of the side motion sensors may be useful for
attaining the desired observation results. You can
activate/deactivate the side motion sensors by
following the steps on Page 12.
Align the camera as follows:
Fasten the camera to a tree or a similar object at
a height of 3-6 feet and align the camera in a
desired direction. Then move slowly from one
side of the target area to the other side. While
doing this, monitor the motion display.
• If this lights up in BLUE , you have been
detected by one of the activated side motion
sensors .
• If it lights up in RED , you have been detected
by the front motion sensor. In this way, you
can work out the best alignment for the
camera.
The motion display only lights up when the
operating mode selector switch is in the TEST
position and one of the motion sensors has
detected movement. During normal operation,
there will be no LED display in this case.
To ensure that the camera does not make
unwanted recordings of relevant movements,
it should not be set up in a sunny location or
close to branches that move in the wind. The
recording angle of the sensors is about 100 °
from corner to corner; and the recording field for
photos and videos is around 89 °.
CAMERA IS READY TO USE - Switch
to ON Mode
After changing to the desired settings and simply
sliding to ON Mode, the camera is in active
standby mode and will record media according
to the switch settings.
Firstly, the motion indicator LED will blink
red for about 15 seconds. Any motion
detected by the side PIR sensor will be
captured by the camera without a trigger.
As soon as the further motion is detected by
the central PIR sensor within 5 minutes, the
camera will take photos or videos.
Otherwise, the unit will return to standby
status .