12
REXENER SILENCE, INSTALLATION INSTRUCTIONS
Installation of the wood stove
•
The stove must be installed on an even surface, and at the same level as the hot tub kit frame’s
bottom.
•
The upper return water hose must be ascending seen from the stove, whereas the lower suction
hose must be in a horizontal position or at a slightly descending angle in relation to the feed
through.
•
If necessary, the rubber hoses delivered with the hot tub kit should be shortened as appropriate.
•
The free circulation of water must not be closed because of pressure accumulation.
•
It is also recommended that concrete slabs, for example, be installed under the frame and stove to
improve air circulation.
•
Make sure that the heating device has been completely filled with water before you start heating
Smoke pipes of the wood stove
•
The smoke pipes included in the hot tub are made of stainless steel. The package includes 2 x 1,000
mm interconnectable smoke pipes. One of them has a pipe hat. The smoke pipes are installed inside
each other by the seams and placed on top of the stove’s smoke hole.
Installing the smoke pipes to the wood stove
•
The lower pipe is a straight pipe, installed inside the collar on top of the stove. The upper pipe is
equipped with an integrated pipe hat and installed to extend the lower pipe.
Water hoses of the wood stove
•
The hoses of the stove have been pre-installed.
•
The hoses are attached to the stove so that the lower suction hose is connected to the stove’s lowest
connection, and the upper return hose is connected to the uppermost connection of the stove.
•
The suction and return hoses have been pre-cut to a length of ca. 35–40 cm. The hoses can be
shortened as necessary by cutting them.